When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2PCS Roof Drip Molding Weatherstrip Left & Right Roof Side Finish Molding for Toyota Tacoma Double Cab
Replace missing, loose, cracked or worn roof drip moldings with this complete left-and-right replacement set. Designed for the factory roof molding channel on 2005-2015 Toyota Tacoma Double Cab models.
Product Highlights
- Complete 2-piece set: one right-side molding and one left-side molding
- Clean OEM-style roofline appearance
- Designed as a direct replacement for the original roof drip side finish molding
- Helps restore the finished appearance of the roof edge and molding channel
- Suitable for 2005-2015 Toyota Tacoma Double Cab trucks
Fitment YearMakeModelBody Style2005-2015ToyotaTacomaDouble Cab / 4-Door
Fits Tacoma Double Cab models with either the 2.7L 4-cylinder or 4.0L V6 engine. The controlling fitment factor is the cab style and roof molding channel.
Important Fitment Notice
- For Double Cab models only.
- Not for Regular Cab or Access Cab models.
- Some trucks equipped with a factory roof rack may not use visible roof drip moldings in the same configuration. Please compare your roof channel and original molding before ordering.
- Vehicle left means driver side; vehicle right means passenger side in the United States.
- Please compare the part numbers and product shape before purchase.
OE / OEM Reference Numbers PositionCurrent Reference NumberReplacesRight / Passenger Side75551-0406375551-04060, 75551-04061, 75551-04062Left / Driver Side75552-0406375552-04060, 75552-04061, 75552-04062 Package Includes
- 1 x Right / Passenger-Side Roof Drip Molding
- 1 x Left / Driver-Side Roof Drip Molding
Mounting clips, double-sided tape and adhesive are not included unless specifically shown in the listing photos or package details.
Installation Notes
- Carefully remove the original molding and any remaining adhesive or tape.
- Test-fit the left and right pieces before final installation.
- Clean and completely dry the roof channel.
- Use suitable automotive molding adhesive or primer if required by the installation method.
- Press the molding evenly into position and allow adhesive to cure according to the adhesive manufacturer’s instructions.
Toyota, Tacoma and the listed part numbers are used for identification and compatibility reference only. This is an aftermarket replacement part and is not a Genuine Toyota part.
