Pro Competition Rig fits Walther PDP 4.5\'\' Steel Frame - Holster, Belt, Pouches For Sale

Everything you need to step up to the line. One box, match ready.

The Pro Competition Rig pairs our Pro Competition Holster, molded for the Walther PDP 4.5\'\' Steel Frame, with the Pro HD Competition Belt and four Amofferextrous Single/Double Stack Competition Magazine Pouches. Built for USPSA, IPSC, and 3-Gun.

INCLUDED

1x Pro Competition Holster (Black or Carbon Fiber, right-hand draw)

• Molded for the Walther PDP 4.5\'\' Steel Frame
• Adjustable ride height, draw angle, and retention
• Competition cut clears any slide-mounted optic
• Open muzzle design allows threaded barrels
• Aluminum thigh spacer keeps the gun at a true 90 degrees for a repeatable draw

1x Pro HD Competition Belt (Black)

• Two-piece inner and outer hook and loop system with belt keeper
• 1.5\'\' wide, rigid 9mm outer belt over a 5mm inner belt
• Carries a fully loaded firearm and pouches without sagging

4x Ambi Single/Double Stack Competition Magazine Pouches (Black)

• Fits 9mm and .40 S&W double-stack magazines
• Adjustable angle, ride height, and pivot
• Thumb screw retention you can fine-tune on the fly
• Mounts to any 1.5\'\' competition belt

Required tools:

• 5mm Allen key: adjusts angle, ride height, and pivot
• 2mm Allen key: belt attachment screws

To mount a pouch on the belt, loosen the four 2mm screws to widen the belt slot. We recommend loosening the 5mm center screw first and rotating the pouch so you have clear access to the four screws.

HOW TO CHOOSE THE RIGHT BELT SIZE

1. Measure your waist where you plan to wear the belt. Use a soft tape measure, run it around your body over your pants (not bare skin), and pull it snug but not tight. Write that number down.
2. Add 9 inches (about 23 cm) to your waist measurement. That total is the belt length you need. The extra 9 inches is the overlap, the section where the outer belt\'s hook-and-loop wraps around and grips the inner belt. Less than 9 inches of contact and the belt won\'t hold securely.
3. Compare your total to the OAL column below and pick the size whose OAL is equal to or just larger than your number.

Example: a 36\" waist plus 9\" overlap is 45\". That means you need at least a Large (46.5\" OAL).

SizeOAL (Overall Length)OverlapFits a waist up toSmall38.5\" (97.79 cm)9\" (22.86 cm)29.5\" (75 cm)Medium43\" (109.22 cm)9\" (22.86 cm)34\" (86.4 cm)Large46.5\" (118.11 cm)9\" (22.86 cm)37.5\" (95.3 cm)X-Large50\" (127 cm)9\" (22.86 cm)41\" (104.1 cm)XX-Large54\" (137.16 cm)9\" (22.86 cm)45\" (114.3 cm)

Tip: if your waist falls between two sizes, go up. Extra overlap just means more hook-and-loop contact, which holds even better. If the belt is too short, you won\'t have enough Velcro contact to keep it closed.